 | ||||||
THE WAY IT SHOULDNT BE DONE
Copyright © 2005 - 2008. Ozon Lpg Installations Ltd. All Rights Reserved.
| ||||||
What a lovely "Approved" filling point :) :) :)
| ||||||
"Nice" pipe work been done, looks like they've run out of clips :)
| ||||||
Interesting wiring solution
Very interesting and unsafe way of doing pipe work for 4x4,- would you like to go off road???
Someone run out of insulation tape :)
Oooo! someone likes the smell of gas everytime he fills up his car. And multivalve is without pressure relieve valve- if it catches fire its gonna go BANG!!!
| ||||||
Definitely Temperature Sensor would work better if it would be screwed into reducer :)
First of all its a GAS Pressure Sensor, secondly it's upside down. Nice strapping :) :)
| ||||||
Flashlube - Valve Lubrication Bottle.
Shouldn't it be fixed in upright position for dispenser to work properly???
If GAS ECU Doesn't fit you always can do some modifications to it to make it fit, its much easier than to find another place :) :) :)
| ||||||
QUESTION OF THE WEEK ! ! !
What load is required for the next HUMP
to damage gas line ? ? ?
P.S. it is seven seater with luggage compartment :)
Dear Owners of them vehicles ! ! !
We would like to assure you that these pictures are not intended in any way to hurt your personal feelings or to be reported to any organisations. Non of the vehicle details been stored or recorded for any Legal or illegal use and all your identities are protected.
This is your personal safety and its totally up to you what you are going to do about it, this pictures been taken for other people to see how the things can go wrong if the installer is not carefully selected.
| ||||||
This picture (on the LEFT) been taken after the owner of the vehicle forgot to disconnect the filling gun from the filling point before driving off. The idea of this picture is to show the danger of fitting LPG filling point into plastic bumpers which is commonly requested by many customers (..." I don't want to ruin my bodywork" exe...) Health and Safety says: Should you forget to disconnect the nozzle of the filling gun and drive off, the filling point have to withstand the pulling power of the filling hose, so it can brake off on the pump which has special emergency disconnection valve, which seals itself once its been broken.
P.S. This customer was sort of lucky, as he stopped straight away, but could rip off all the pipe work as well attached to the full tank of gas.
That's why we always recommend to fit the filling point into metal surface, all cuts are treated with anti-rust chemicals and if requested it can be colourcoded also as shown on the RIGHT picture.
